PDA

View Full Version : Mazda 3 2004 1.6d EDC16 DPF and EGR off



mitaka1970
10th December, 2015, 05:35 PM
346137
Hello. Please help me to disable DPF and EGR on this car:
Mazda 3 2004 1.6cdti Ecu BOSCH 0281012530 EDC16. I tried with VOLTA and ECU safe, but it does not.
Thank you !!!!!!!

mihaiservice
10th December, 2015, 05:55 PM
Hi
can you upload all dtc stored in ecu ? maybe something are wrong on ecu configuration !

pipina
10th December, 2015, 06:13 PM
346141

Hi, here you have.

regards

mitaka1970
10th December, 2015, 07:25 PM
Thanks This is everything I read. 346162
Tomorrow I will try to file pipina and write the result.

mitaka1970
11th December, 2015, 02:46 PM
I removed the DPF filter. Many clogged. The recorded file from Pipina. The car starts normally but then enter into emergency mode and loses Engine Power. In FACM module has the following errors P1927 and P1927. Errors engine P2584.

mitaka1970
11th December, 2015, 02:51 PM
When I turn additives under the rear seat. when the engine appeared error U0118

mihaiservice
11th December, 2015, 02:55 PM
P1927 : Fuel Additive level too low/empty
P2585 : Fuel Additive Control Module Warning Lamp Request
Possible causes are:
1.No fuel additive in fuel additive tank
2.Fuel additive system malfunction
3.Fuel additive level sensor malfunction
4.Fuel additive control module malfunction

also this dtc was stored in ecu before before remove dpf pipe....but !

pipina
15th December, 2015, 05:56 PM
If you have unpluged additive module the car must run ok ... exept Uxxxx DTC

mitaka1970
17th December, 2015, 02:53 PM
The car is ready thanks to Babos . Very competent specialist. Many thanks for the help of all. The topic is closed.