feti589
14th December, 2015, 12:41 PM
Hello everybody
I made an OBD 2 (female) diag connector, to test ecu's after programming.
For ecu who communicate with K-line it work well, but I tested with an edc17c10 and that don't work.
I used correct pinout, can-h and can-low connected, wiring checked and everything it's ok..but no answer to diag.
It's impossible to do a diag on bench for can ecu's ?
I made an OBD 2 (female) diag connector, to test ecu's after programming.
For ecu who communicate with K-line it work well, but I tested with an edc17c10 and that don't work.
I used correct pinout, can-h and can-low connected, wiring checked and everything it's ok..but no answer to diag.
It's impossible to do a diag on bench for can ecu's ?