View Full Version : 2011 transit speed limiter
ninja123
15th December, 2015, 08:39 AM
I need to remove speed limiter from ECU, I try from BSi but not work, The ECU was re mapped, if I change from 70mph in BSi then I get warning light on dash and fault code in ecu - incompatible configuration.
Can anyone help, or have ori file?
ninja
pulsar2000
15th December, 2015, 09:57 AM
Have you tried Ford IDS ?
i thought only on earlier vans was ecu unlock for de limit,
CustomCars
15th December, 2015, 11:48 AM
I need to remove speed limiter from ECU, I try from BSi but not work, The ECU was re mapped, if I change from 70mph in BSi then I get warning light on dash and fault code in ecu - incompatible configuration.
Can anyone help, or have ori file?
ninja
Write type ecu, and model, all info about car.. can get anything from this dump.
ninja123
15th December, 2015, 08:08 PM
2011 2.0 dtci SWB front wheel drive transit van.
I will get ecu details and put them here.
flyins
15th December, 2015, 11:05 PM
2011 2.0 dtci SWB front wheel drive transit van.
I will get ecu details and put them here.
Friend can you not just reflash engine ecu with ids with last calibration and then in service functions disable speed limit? I assuming you have ids as you try to remove from BCM but have no success.
This would be an easy way friend.
ninja123
16th December, 2015, 08:44 AM
My IDS is clone so dont want to try this, I have AVDI so can re flash ECU if I can get good file or latest ECU software version.
tunertool
16th December, 2015, 10:33 AM
Clones flash fine... just make sure using jump leads or flash charger.
ninja123
16th December, 2015, 06:57 PM
OK, but where do I get the file from?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.