View Full Version : How to read Golf 6 MM with 9S12XHZ? 1M80F
soxten
23rd December, 2015, 05:17 PM
I can read this by Can-bus and X-tool (km and Eeprom)
BUT how to read this MCU on bench?
I get Boolaoader fault from Xprog every time I try....
I have try both of this pinout but no one is working...
Please do someone know how to read this?
I use this xprog box clone and software 5.45
What program can read sec pin from this dash?
348427
348428
348429
348430
348431
soxten
23rd December, 2015, 05:19 PM
348433another picture
simaservis1108
24th December, 2015, 10:21 AM
Connect BDM adapter to Xprog,then BDM adapter to MCU.
soxten
24th December, 2015, 10:32 AM
Like this?
348516
soxten
25th December, 2015, 11:58 AM
I still get this problem..
I have try 2 diffrent xprog 5,45 and 5,51 but get bdm problem.
I have try with 4 cabel as xprog show and with pinout pictures here abowe.
I can't understand why this mcu is so hard to read...
I have try ti lift reset pin and bkgd pin from pcb but no diffrence.
348630
offsystem
25th December, 2015, 12:49 PM
Try other bkd point maybe bdm is locked
Gesendet von meinem Valencia2_Y100pro mit Tapatalk
rob h
25th December, 2015, 02:34 PM
And remove the red circled part.
soxten
25th December, 2015, 02:52 PM
I did lift pin for BKGD and connect directly on pin. No diffrence.
Do I need to desolder 5mhz component?
As I understan I shuld change from 4 to 5mhz in xprog program?
Rito
26th December, 2015, 02:20 AM
Digi clone can do this dash OBD...
But some MM5 dash whit nec+24c64 is very hard to do..........
soxten
26th December, 2015, 12:13 PM
Over can-bus I can do it with Xtool, read and write Eeprom .
But I whant to do it by direct connection on pcb.
This is not NEC!
Motorola mask 1M80F
I have dash here with nec and 24c64 and on this dash I need to prepair Eeprom first and then solder back on pcb and connect by OBD to read sec code.
(When I work with dash on bench, if its in car xprog reads sec code from comfortmodul and then I can read dash directly. No solder)
offsystem
26th December, 2015, 03:48 PM
How you can read write it with xprog over canbus??
soxten
26th December, 2015, 08:32 PM
Sorry I write wrong!!! :)
Xtool do it over canbus
Xprog cant do it on bdm
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.