PDA

View Full Version : Can you help me clear 98820 9KA0A ?



joeguzman89109
29th December, 2015, 10:57 AM
349124
Hello, Can anyone please help me clear this crash file? Thank you :)

bulanbulanov
29th December, 2015, 11:54 AM
349124
Hello, Can anyone please help me clear this crash file? Thank you :)

please report !

--->>>349130

joeguzman89109
29th December, 2015, 02:22 PM
Thank you bulanbulanov, I will test and report :02.47-tranquillity:

bulanbulanov
29th December, 2015, 04:11 PM
Thank you bulanbulanov, I will test and report :02.47-tranquillity:

problem with thanks button?

janushaan
29th December, 2015, 05:10 PM
problem with thanks button? <-- on his computer thanx button is broken,, :roflmao:

joeguzman89109
30th December, 2015, 02:58 AM
Hi guys, sorry, I did forget to hit the thanks button after I typed thank you on the thread. Sorry for that., and please forgive me. In fact I had made myself a note to report back after testing, and thats exactly what I am doing.

Ok, so here is the report: I installed on car, and the file wokrs perfectly. Thank you again! :02.47-tranquillity: Thank you a million times. :bounce::rock::marchmellow::cheers:and cheers!

joeguzman89109
2nd January, 2016, 11:46 PM
****UPDATE****
Hello again, Sorry, I would like to report that the file did NOT work. At first it appeared to work when the ignition was switched to ON, and the bag turned off after 6 seconds. But the car battery was low. So unfortunately, once the car was jumped and the engine running, the light airbag light came back on. :confusion: It gave me a flash code for SRS Unit Internal Failure. Could the file be the problem?

Thanks again everyone

janushaan
3rd January, 2016, 01:21 AM
do you have a scanner please scan it find out the code

joeguzman89109
3rd January, 2016, 05:13 AM
I do have a scanner that reads airbag codes, but it was unable to communicate with the module. Nissan gives you codes based on the flashing of the airbag light. This one was 1-three second light followed by 7 short flashes. Based on the Nissan flash code table, it says the unit is either not connected properly,or it's not functioning. However, I tested with a known good srs unit. Light stayed off. But when I put this module back, the light came back on. Is a bad file a possibility?