2010 toyota G

[magicworx]

Hi guys
I have a 2010 toyota corolla that i"ve made keys for and programmed chip.Car starts and dies after 3sec.Immo light goes out and
no fault codes on immo.Have fault code B2699 on ecu.Tried bridging 4-13 several times to no avail.Any help PLEASE!
Thanks in advance.

[ilian_cho]

See here what says tango for double key storage:
Continue as in a normal situation and make a key. Then read out the ECU dump and run the ECU keymaker.

There are two classes of immobilization systems used in Toyota after 2004y. with ID67, ID68. The main difference between these classes consist of method

of key's data storage. The simplest class keeps the key's data only in the immo. The more complex class has data stored as in an immo as in an ECU.

Always begin to work with an immo. Read the immo dump and open it with a keymaker.

If you have got the message "This immo also requires programming of ECU", it means that you have the complex immobilization system

Place the same transponder on Tango and click the WRITE button. Thus, you have finally two new dumps (Immo + ECU), each of

them contains the transponder data.
Note: writing into the ECU it is not important which key number selected. For example it is normal to write a key in the immo on

the position 1, while in the ECU on the position 2. ECU doesn't check the key position, it only checks a presence of a key data in the memory.

[magicworx]

Hi
Thanks for reply but tango does not recognize dump.Was given virgin dump by fellow DK member.Any other ideas?

[magicworx]

Any help guys?Is there a way to write sync data to ecu and immo manually?Please help.
thanks.

[Lardle]

pls post original immo dump here....then i'm u can get help...

Regards.

[m-o-y]

you got not recognize , in case of some error reading , so you need to check your dump and edit it.

[magicworx]

Hi Gents
I"m uploading both dumps:first read and read after key added and 35min sync.Car starts and dies after 3sec.Please sync for me???
thanks in advance.

[magicworx]

Please guys,im stumped on this one!Any suggestions?

[bram380]

please info part number immo box
read keys and ecu engine, post here

[magicworx]

@Bram380 or anyone that can help! Hope this is all the info needed.Thanks

[magicworx]

Hi guys
Anyone who has virgin dump for ecu on this vehicle please?

[magicworx]

Please fellow DK members out there! Can anyone shed some light?

[m-o-y]

try , the first one is editing dump , and other editing and selflearning.

[magicworx]

Thanks will try and report today.

[magicworx]

Hi M-O-Y
Car starts and runs for 3sec only.Fault code B2799 wont clear.Need to get this car sorted today guys please help.
Used the self learning file.Immo light goes out.

[m-o-y]

I think , it is only wrong reading.
so are you sure you read in 16bit ?
If yes then then you can edit the dump yourself
anyway try other editing.
good luck

[magicworx]

Still a No Go with this one.Driving(or not!)me insane! Starts and dies after 3sec.:banghead:

[zckariya70]

Still a No Go with this one.Driving(or not!)me insane! Starts and dies after 3sec.:banghead:


i have posted some virgin dumps for u see if it helps for u.

[tierra]

try to change your eeprom;if nothing after this please change your immo box