volvo edc16c34 dtc

[bonux]

Hello friends, i ask for help to delete dtc A600 (P2585) additive module error, i have removed dpf but this fault still active and i cannot remove it, pls help experts,
i have disconnected additive module under rear seat but fault still active
thanks in advance!

[CustomCars]

Hello friends, i ask for help to delete dtc A600 (P2585) additive module error, i have removed dpf but this fault still active and i cannot remove it, pls help experts,
i have disconnected additive module under rear seat but fault still active
thanks in advance!

Bad solution, post here ori.

[Babos]

CustomCars absolutely correct it is bad file,and it is not dpfoff!
I think you post here wronge dump.

[nbtechnic]

hi, bonux thy ori file is not good
post the right file, with the characteristic of the car, it's best to research and assistance!

[Tomanio]

first: the file is bad, second: ADM module is external and to totally delete faults you must change car config in CEM (remove adm from configurtaion)

[bonux]

car came from italy with deleted dtc table, limp mode and smoking alot.(i think dpf-off was done improperly) i found ori file here in forum with same hw/sw numbers, dpf off is switch solution with this ecu, isnt it?
with this file car drives ok only problem is this dtc

[Tomanio]

you must fill ADM fluid (diesel fuel), and reset counter works 100% or remove adm from config.

[nbtechnic]

ok bonux, your file is good, there was a small technical implement to succeed in the decoded.
I would come after post...