Insignia edc17c19 ecu

[catala20032004]

Hello,
Can this ecu be read by obd? If so what tool can do the job. Thanks

[gitko]

only on table can

[GolfmkI]

I dont Know any tool to Obd Job, but I wont risk

Use Ktag / Galletto or whatever tool you want , but on table.

So you can access entire flash / eeprom and restore if you were in problems....

Even if Kess v2 does it ( it doesnt do it ObdII), it suposse so many risk....

Make job on table worth every penny and every minute/ hour.

Good luck

[elmassioui]

Hi
K-TAG ,Galletto V50.53.54 CLONE work good in this ecu. INT flash & EEPROM INSIDE. :)

[ecutuners]

If sw number starts 39xxxx obd is fine, if starts with 5xxxxx Boot mode only

[tunertool]

If you need DPF off then full boot mode read is required... OBD not enough.

[Tes1a]

yes that is opel !!!!!!!!!!!!!!!

[ecutuners]

If you need DPF off then full boot mode read is required... OBD not enough.

I done many dpf and tune on the obd ones all fine over a year later

[tunertool]

You were lucky then

[groudy]

I done many dpf and tune on the obd ones all fine over a year later

With Kess V2?

[ecutuners]

Yes with sw numbers 39xxxx if its 5xxxxx you need boot