View Full Version : Insignia edc17c19 ecu
catala20032004
24th January, 2016, 08:58 PM
Hello,
Can this ecu be read by obd? If so what tool can do the job. Thanks
gitko
24th January, 2016, 09:58 PM
only on table can
GolfmkI
25th January, 2016, 04:16 PM
I dont Know any tool to Obd Job, but I wont risk
Use Ktag / Galletto or whatever tool you want , but on table.
So you can access entire flash / eeprom and restore if you were in problems....
Even if Kess v2 does it ( it doesnt do it ObdII), it suposse so many risk....
Make job on table worth every penny and every minute/ hour.
Good luck
elmassioui
31st January, 2016, 12:07 PM
Hi
K-TAG ,Galletto V50.53.54 CLONE work good in this ecu. INT flash & EEPROM INSIDE. :)
ecutuners
31st January, 2016, 12:22 PM
If sw number starts 39xxxx obd is fine, if starts with 5xxxxx Boot mode only
tunertool
31st January, 2016, 05:42 PM
If you need DPF off then full boot mode read is required... OBD not enough.
Tes1a
31st January, 2016, 06:41 PM
yes that is opel !!!!!!!!!!!!!!!
ecutuners
31st January, 2016, 09:12 PM
If you need DPF off then full boot mode read is required... OBD not enough.
I done many dpf and tune on the obd ones all fine over a year later
tunertool
2nd February, 2016, 12:33 AM
You were lucky then
groudy
6th February, 2016, 03:24 PM
I done many dpf and tune on the obd ones all fine over a year later
With Kess V2?
ecutuners
6th February, 2016, 03:27 PM
Yes with sw numbers 39xxxx if its 5xxxxx you need boot
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.