PDA

View Full Version : NISSAN PATHFINDER 2006 2.5D reprogramming key


STEEVYAS
30th January, 2016, 10:23 PM
Goodnight

Faced with such a problem - when initializing a new block of navigation keys are erased, and again I can not be programmed. I do LAUNCH DIAGUN3. The procedure begins, programming key, at the end I turn the ignition key NATS first goes out, and the next time the ignition is switched on continuously NATS. It seems that the procedure does not end there, and the reason I can not understand. Although the key is inserted NATS blinks five times. Tried to register 9736 - after programming TANGO it shows that the chip is blocked.

For information - lamb in the presence of two keys. In addition to tidy NATS lit red KEY and LOCK.

Available X100PRO (unable to connect successfully, but deducted PIN), CK-100 - the car behaves as with LAUNCH.
Kellerek
30th January, 2016, 10:50 PM
what code you got with launch in bcm ?
STEEVYAS
30th January, 2016, 11:13 PM
what code you got with launch in bcm ?

Pin Code 3210
Kellerek
31st January, 2016, 12:11 AM
do you know what is bcm seed code (5 digits/numbers)
STEEVYAS
31st January, 2016, 12:32 AM
do you know what is bcm seed code (5 digits/numbers)
yes, EB2CC
Kellerek
31st January, 2016, 01:28 AM
ok try 5817
autocheck
31st January, 2016, 06:49 AM
That Nissan only accept remote keys with pcf7946 . Have had the same problem before. Good luck

Sent from my SM-G350E using Tapatalk
STEEVYAS
31st January, 2016, 10:09 AM
That Nissan only accept remote keys with pcf7946 . Have had the same problem before. Good luck

Sent from my SM-G350E using Tapatalk

This is a misconception . The problem was in the trailer presence sting key. In addition, the chip has been registered PCF7936. Sorry for my bad technical English.