TOYOTA PASSO 2011

[gisellecelica]

Hello friends
I am Giselle I would like to share with you some information about toyota passo 2011 with keyfree system this dumps are swap byte, in it are registered one smartkey and one transponder key like you will see in gscan screenshot so ra57 ecu dump in line 0x00 8fc2 ba64 repeated 3 times is in c66 keyfree dump line 0x50 like 64ba c28f repeated 3 times too I think they are synchro bytes between ecu and keyfree box the smartkey is registered between line 0x070 and 0x0A0 readed with zedbull 6A47 D32A pg3 and in line 0x160 is registered transponder key repeated 3 times

[Niaz]

Hello friends
I am Giselle I would like to share with you some information about toyota passo 2011 with keyfree system this dumps are swap byte, in it are registered one smartkey and one transponder key like you will see in gscan screenshot so ra57 ecu dump in line 0x00 8fc2 ba64 repeated 3 times is in c66 keyfree dump line 0x50 like 64ba c28f repeated 3 times too I think they are synchro bytes between ecu and keyfree box the smartkey is registered between line 0x070 and 0x0A0 readed with zedbull 6A47 D32A pg3 and in line 0x160 is registered transponder key repeated 3 times
Exactly you told right everything in dump.. mine is little different from your bin dump from address 00 to 01 but other structure is same..& attached a reset dump "just need to leave address 38 to 43 as it is no matter what data is was in original bin other data all fill with ff's.." . but i think it is manual procedure to program daihatsu type key!! i can add 1 key but want to know how to add second key ? 1st key procedure is = write reset dump in eeprom, immo light must be steady put key in ignition & push with twisting knob & remove key then push only twisting knob "with your finger" immo light must start blinking then insert key again in ignition & leave till door lock & unlock once . your 1 key is registered, don't know how to add second ? :)

[Justsuper]

I can confirm that Khizar Butt reset works by FF-ing everything except location 38 to 43 and only works with 4D transponder that has Page 1 = 3D , but like to add that at the end the immo light still flashes and what I did was to bridge pin 4 and 13 for about 5 minutes and light stop flashing and car start.
Now I would love to figure out how to program smart key.

Picture of key is my gift to this project :):)

Thanks again Khizar Butt its makes a big difference.