View Full Version : Kenwood HDV-910
locomo
3rd February, 2016, 01:24 PM
Please help found code in dump.
smoggy
3rd February, 2016, 01:34 PM
I think bad dump
shooting
3rd February, 2016, 01:55 PM
Please help found code in dump.
I think this is the wrong eeprom, I think you need dump from 24c04 from mech
wbr
locomo
3rd February, 2016, 03:47 PM
On mainboard near processor M30835FJGP only one EEPROM 24C01 smd.
On the rear panel under silver label there is a connector on 5 Pin similar to ICSP for in-circuit programming,
Is it possible to read and write direct in EEPROM?
ilian_cho
3rd February, 2016, 06:20 PM
This dump is with 1234 code try.
locomo
8th February, 2016, 03:38 PM
This dump is with 1234 code try.
I try but device go in "DEMO" mode, without ask code.
How to get "NORMAL" mode?
ilian_cho
8th February, 2016, 06:01 PM
Try with "AUTO" abd "TRACK UP " butons
locomo
9th February, 2016, 12:55 AM
Thanks ilian_cho, all worked right and code 1234.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.