astra h GID display no canbus comunication

[niku202005]

Hi, i have an astra h GID display, it work fine, but from one week, it wont start with ignition on, on temperature it show me F, and when i read error, its siad" DIS no comunication with IPC, UEC, CIM, i think, IS any chance to make'it work again?, does anyone solve this problem?,
any solution is welcome.
thank's in advance .

[stachu22]

If you can connect to DIS via opcom or tech than I think that communication on CAN is good. Maybe index code is wrong? Try to reprogramm DIS, check configuration of HIGH, MID, LOW CAN or total reprogramm eeprom by programmer.

[niku202005]

ill try to reprogram eeprom, to see what happen. thank's

[stachu22]

Tell me what kind of GID you have? Maybe I have unsigned dump. GID SE?

[niku202005]

se is ident.

[stachu22]

Here for you 2 dumps for GID SE:

356644

[niku202005]

thank's a lot, but it seems that display is not starting anymore, i think is the coil burned, is still under investigation

[ilian_cho]

Try to replase can chips. Into astra displays must be TJA1054 or similar. For orientation see can filter