2016 HYUNDAI TUCSON 95910-D3200 HELP

[amlgarA]

need some help solder points this module made by autoliv 95910 -D3200 , inside xc2361, PLUGS are different not able to read by carprog, OR SOLDER POINTS BY ETL OR CPT, thanks

[auto80]

post photos

[amlgarA]

XC2361 MODULE MADY BY AUTOLIV

[amlgarA]

any idea to clear this dump, TUNING DATA, FAIL TO DETECT CRASH

[FxShaw]

Try out and let me know.

[amlgarA]

thanks for try , but I have never clear one of this, like you did, do you? WITH OUT CLEARING JUST AND AREA, always need modification, I used to use one clear for other models , like 2014-2015-2016 santa fe, xc2361 and sportage 2015-2016 Sorrento 2014-2015-2016 using tunning data adjust dump , in memory , always used the same procedure as tunning, take long to do it because you need 65536 bits, but this DUMP 2016 is different, I tried and get , all codes deployment in all airbags and track control and blind spot light turn on

[FxShaw]

I dont get alot of these at all..the ones I did get was done by me clearing them manually..This one is different from the rest so I am trying something totally different for this one..

[Afreendalal]

Hello, I need point to read this unit. . Thanks

[amlgarA]

Hello, I need point to read this unit. . Thanks


I asked the same thing , and I spend around 16 hours figuring out.. is easy to ask, but sometimes nobody help and then you don't want to help also just the people help you...

[Afreendalal]

Thanks brother. ..for helping

[Catdaddyfunk]

thanks for try , but I have never clear one of this, like you did, do you? WITH OUT CLEARING JUST AND AREA, always need modification, I used to use one clear for other models , like 2014-2015-2016 santa fe, xc2361 and sportage 2015-2016 Sorrento 2014-2015-2016 using tunning data adjust dump , in memory , always used the same procedure as tunning, take long to do it because you need 65536 bits, but this DUMP 2016 is different, I tried and get , all codes deployment in all airbags and track control and blind spot light turn on


Did you get it to work? I didn't see you report back.

[auto80]

Did you get it to work? I didn't see you report back.

And why do you want report from him ? Did you try at least help him :questionmark: Or you want only GOOD solutions and give bad reputations here at people who try to help

HELP more the others too, m8

[luis12]

Bad thing when discussing beetween friends, all are in the same work, Almgar if posible can yo tell me if did direct pin conection or made conection for reverse side, have a 2015 Sorrento and board is similar, need to make any short ??. I have ETL org but this board dont figure I have only micro pin out, Thanks to any help.

[amrif]

XC2361 MODULE MADY BY AUTOLIV

do you have pinout? I'm found this but upa can't recognized CPU