Ford focus c-max need DPF OFF

[sppeedy]

Hi,
I need dpf off in ford focus c-max.
I tried with switches but car still can only 3000rpm max.

Original file edc16c34 sw:1037396911 357155

Regards and thank in advance

[mihaiservice]

Hi
if car are in limp mode with your dpf off file also must store some dtc,wich one are stored in ecu ?

[sppeedy]

Thanks mihaiservice (http://www.digital-kaos.co.uk/forums/member.php/106636-mihaiservice) for reply,
I check errors on the weekend because it is the car my brother in law

[centrohifi]

disconnect ECU Dpf ... send error U......

[soundnavigator]

Post your DPF OFF file for check. If all OK ... I have one idea. I have the same problem on Mazda 3 1.6 D ... really is the same.

BR

[CustomCars]

LIMP should be not possible without DTC, someone must touched table.
Did u compare file with other orginal to be sure ?

[sppeedy]

hi,

thanks everyone for your interest in my problem.
This is my dpf off file 357295

[CustomCars]

Your solution is not fully, and for me bad.
Make try with only second byte - Restore first and last one.

I think you copy solution from somewhere and don't checked it correctly

[soundnavigator]

The switches is right, but solution not full. With original software the car is in limp mode ... at first time ?

[sppeedy]

yes, car was on limp mode before dpf off

CustomCars (http://www.digital-kaos.co.uk/forums/member.php/444023-CustomCars)
tomorrow i try with only second byte,
i dont copy solution i read about on ecuedit forum and i manualy change my original file

[soundnavigator]

OK, the car is in limp mode becouse have stored DTC for DPF ... if you make reset and delete it ... at first time have limp mode ?

I have the same problem on Mazda 3 1.6D. With full DPF OFF no errors and the car still in limp mode. When changed glow plugs ... all was ok.

If the problems is the same, need to change glow plugs for test or some special correction in software.

[sppeedy]

Hello,
on the weekend i did not read errors
because brother in law was busy.
I have a question whether my original file is correct, because it was read with mpps. On another forum I found a file with the ECU with the same SW.
And this file is different from mine.

This is the file:
https://mega.nz/#!55xT3CbS!0TlDQDTIV8yu5KVryTnZMBt7AcA0PPirf2khxwZ DZJk

[soundnavigator]

The file is OK as OBD read.

[silvergl]

friend, you have problem p1187 ;) read by bdm send e2p.

[sppeedy]

Thanks all for helping in my thread,
The problem was with glow plugs.
After replace all is ok