View Full Version : Fgtech galetto (original) renesas write problem
kari11
13th February, 2016, 04:11 AM
Hello,
I want honda accord ECU tuning. The reading is no problem. The writing was 100 minutes (!), And after he sent an error message (I contact the support). I ended on the basis of the images. I tried writing the resistors is desolder, but it does not work. Can someone help me, what is the problem? (Sorry for knowledge of English :))
MCU: 7055
Thnaks
Kari
teerak2uk
13th February, 2016, 09:20 AM
Have you asked Fgtech support?
kari11
13th February, 2016, 10:30 AM
Have you asked Fgtech support?
At the weekend I can not reach them.
CustomCars
13th February, 2016, 11:05 AM
Long read say about some resistance problem.
If i will be free time try help. This ecu should have some alternative connection.
kari11
14th February, 2016, 01:44 PM
Long read say about some resistance problem.
If i will be free time try help. This ecu should have some alternative connection.
Unfortunately I can not try another programmer.
dadal
4th December, 2016, 07:01 PM
did someone solve this write problem, ? I have also write problem witht CLone ( reworked)
Pali33
27th February, 2018, 04:50 PM
i have renesas write problem too (FGtech4) . Read no problem (SH7058, opel Denso Z17DTR)
Have anybody solusion for this?
thanks
voltechcar
27th February, 2018, 10:20 PM
Use K-tag, hes work
bersch8688
28th February, 2018, 06:46 PM
Like my Ktag too
Read & Write DENSO without Problem
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.