2014 KIA Cadenza SRS 95910-3R100 Autolive w/ MAC7242

[12v]

Hi,
Can somebody help me clear crash or internal fault for airbag KIA Catenza 95910-3R100
inside MAC7242

i have one flood unit with internal fault and one crash

CarProg calc not recognize crash

Thank You for any help

[mcm44]

I can repair that, but you have to read whole MCU.
FLASH 256 KB
EEPROM 64 KB
SHADOW 32 KB
from both units...
:)

[12v]

i have full flash (w/ eeprom) and shadow x-prog files

if you need i can modify files for your size

[credoline]

XprogM software read bad files.

[12v]

XprogM software read bad files.

what did you mean??

[12v]

and files from same modules readed MACACA

[credoline]

MACACA read OK. And XPROGM read ok, but i am overlooked data part at the end of file. From 40000 to 4FFFF is data part of file in XPROGM file. Because i have seen here many files from XPROGM read not good. In part of dump where need to be all values FF programmer read some other values that repeat.

[credoline]

Try like this and please report. If file work, after put in car, erase dtc and read again and save dump.

[12v]

no good
i had 2 crash DTCs
with your file i have 2 crash DTCs + 1 Internal fault DTC

and can't clear

[credoline]

OK, try next for any changes

[12v]

no good
same errors:
B1620
B1670
B1655

[MOHCIN2]

IF you will try just the crash data instead of your ori one it will not work without the data of the flash of the same eeprom data you will get internal error or fault its better to make clear your original file or virgine solution

[12v]

Can you clear internal fault from original module, or you have virgin dump?

[builes]

credoline (http://www.digital-kaos.co.uk/forums/member.php/89856-credoline) you have many erreur in your fille in many cars

thanks you

[mcm44]

12v: You have all you need to repair your unit. :) Just think, what you did not try?

If you want a hint, let me know... :)