PDA

View Full Version : Micro not supported...



heteromies
20th February, 2016, 01:56 PM
I'll have reworked galletto 0475 and tried testing how BDM works. ECU is Bosch VAG MED9.1 But after try to read ecu id, soft fail and got popup "micro not supported..." OR maybe BDM not work at all, i don't know what kind of error comes then....

So what could be wrong or reason for popup?

Who knows what parts are for BDM in galletto?

heteromies
22nd February, 2016, 06:36 AM
Any suggestions?

Andrei2015
22nd February, 2016, 07:58 AM
did u solder ot used probe?

heteromies
22nd February, 2016, 08:20 AM
did u solder ot used probe?

I used Bosch probe. Do you think its probe problem maybe(bad contact or something)...? I have tested with multimeter and probe should be ok(continous testing) How pins order should be?
Do i need also use extra power supply for via ECU connections pins? I use extra power supply(13.8V) via adapter for flat-cable, like galletto BDM manual says.

pocket cinema
22nd February, 2016, 01:51 PM
test on anotehr ecu. med 9.1 is not the most BDM frendly ecu....

Andrei2015
22nd February, 2016, 04:14 PM
just did med9.1 on bdm with clone, no problem, but need to check if all pins make good contact. Alo make sure you use external power and bosch adapter for galletto