PDA

View Full Version : Crafter edc17 dpf off


sepistar
4th March, 2016, 06:45 AM
Guys,
need dpf and adblue turning off for this car:
crafter edc17cp20 2,5 tdi engine
361720
Thks.
sepistar
4th March, 2016, 04:13 PM
just want to move the car,mount ecu back ,(original software) car not cranking,therefore not starting!?
ecu boot normally on.all lights goes on then off(except mil,dpf and glow lamp,it was yesterday the same but car runs)
although original software,have wrote back the backup,no change.
have checked all the fuses,relays,everything ok.
starter became no feed.
from yesterday 2 erors in addition:
008852 pressure valve for diesel N276
P2294-000-interrupted
000145 fuel metering valve N290
P0091-000-shorted on ground
but i think that normally car should at least crank.
any ideas are welcome.
sepistar
4th March, 2016, 05:35 PM
forgot to say that early today have try to make tprot off.
but ktag refuse to write anything.
after that read ecu again(to check if files are ok)and,they are indeed the same as first readout.
so nothing corrupting.
sepistar
4th March, 2016, 06:24 PM
never made immooff on edc17,but if immooff,can be started another car same engine,with it?
just want to be sure that the ecu are ok.
mihaiservice
4th March, 2016, 06:34 PM
Not sure if that ecu will be ok also with immo off,starter will be locked via CAN BUS from SCR module !
sepistar
4th March, 2016, 07:19 PM
Thks.for input mate.
you mind that ad blue module can block the starter?
mihaiservice
4th March, 2016, 08:20 PM
If it show "0 km,contact your local service" in the cluster than starter are locked !
you can reset adblue level with VCDS or VasPC,will get more 50km to drive at service/workshop !
sepistar
5th March, 2016, 07:15 AM
people,someone can take off ad blue and dpf from my file?
soundnavigator
5th March, 2016, 10:12 AM
Maybe, but if the car not start after that ... where will be the problem ... on the car or on the file ... ?

Better is to have started car and then to make others.

What tool you use ... ori or clone ?
sepistar
5th March, 2016, 12:13 PM
The problem with engine start is solved.
Under ecu are some connectors.
One of them was loose.
Sh..t.
Anyway the main question remain,please dpf and adblue off.
sepistar
6th March, 2016, 03:44 PM
I've made dpf off,car runs fine.
Please somebody to turn adblue off.
sepistar
7th March, 2016, 05:47 PM
Can be closed.