PDA

View Full Version : Skybox F5S freezing



CrAcKeDuPII
6th March, 2016, 08:40 PM
Hi there,

I have a couple of F5S boxes that freeze after a period of time. It happens to both FTA & SLY channels. On one box it can be every 20 minutes or so and on the other one it is normally ok for a few hours, before I get the green frozen screen. The box that goes a few hours also freezes immediately if you put an HD channel on - SD is fine.

I've have heard that the tuners overheat but was wondering if anybody can confirm if this is the case and what, if any, solutions there may be.

Both boxes are out of warranty, so sending them back is not an option.

I realize the Openbox/Skybox are cheap and cheerful units, but have founds lots of problems with them right from the early days of the S8......they all seem to go after a year or more.....power supplies and tuners being the main culprits. You gets what you pays for I know! :greedy_dollars:

Any info much appreciated.

362154

hfxlad
8th March, 2016, 07:12 PM
if it is freezing on your fta channels and its doing it on both boxes then that could be a dish probem
after the weather we have ad then it is very likely but as i say could be.
so have your dish realigned as the dish could of moved slightly and this would cause it to freeze and if it as moved
then there is play and any slight wind can move it .

CrAcKeDuPII
11th March, 2016, 01:38 PM
Thanks hfxlad. I should have said the boxes are in different locations running off separate dishes.....

hfxlad
12th March, 2016, 05:44 PM
well it you have two dishes it still could be a alignment issue as i would not think that the cable or fittings
would go down at the same time.you cold try a different reciever if you have one or could borrow one.also press your imfo button and check on the right hand side what your snr number is anything over 70 is good if its under 60 then theres a problem with your signal.and you could also put new firmware on but remember to backup certain things but it does not point to firmware but you have nothing to loose as long as you backup.the image you provided is a pixal problem which says dish alignment or cable or connectors.

Mee?kat
19th March, 2016, 07:45 PM
Does not sound like a signal issue to me but the best way to check that if you dont have a signal meter is to plug in an official skybox and check the signal levels from there.

Sounds more software/hardware related so i would look into upgrading the firmware on the boxes after signals have been checked.