Jeep Commander 3.0CRDI DTC OFF

[immokill]

Hello

Can somebody delete DTC P2015 , P2017 on this EDC16CP31 ECU .

Please help


Regards

Thanks

[immokill]

Please help :(

[bobolin4o]

Mate, can't find P2017 in dump...
EDIT... What is the problem... and what are those codes... OBD, or manufacturer specific...?
I mean, which tool you use to read DTCs.

[immokill]

Thanks bro. I readed codes with st6000 , and delphi eobd option, not specific man.code. Car goes in limp and dtc is intake manifold position .
your file is same problem ,lamp is blinking on dash but no cedes on obd.

Thanks ,

Regards

[gitko]

removing of dtc doesn't help you.
You need good decision.

[immokill]

Motor for intake flaps?

[gitko]

yes I know what is it

[immokill]

Can you help ? EGR?

[gitko]

first intake manifold position now EGR.

Way?

[immokill]

I put 4.7kohm on intake motor and all ok?

[gitko]

here egr off

[immokill]

Thanks bro tomorrow i will try it.
Thanks
Regards

[fargulkim]

Here is...tested...pm

[gitko]

this is with connect plug

[bobolin4o]

I put 4.7kohm on intake motor and all ok?

My file is only DTC off (as you wanted), of course will not solve the problem with limp mode.
If the actuator plug have 3 wires, yes, you can try with resistor (put it between "+" and "signal").
But you must make 3 FULL ignition cycles after that.
Switch ignition on, start the car, wait 1 minute, turn it off, remove the key, wait 1 minute... 3 times...
Try, nothing to lose.

[immokill]

Thanks ,i combined 3 files above ,and all OK . No lamp blinking and no limp with fargulkim file too.

Thanks

Regards