morphvale
15th March, 2016, 05:29 PM
Hi Guys,
I need your help with some issue that I have.
I'm trying to tune my Ford Focus, and increase the power to around 305Nm and 135Hp and also disable DPF (switch method) and EGR (hysteresis method).
Most of my tune works fine, however, I seem not to be able to go over 264Nm of requested torque (as read by Forscan) for some reason. I can surely feel an improvement and all the values (besides the net engine torque from the attached image) are correct in Forscan.
Test run:
363864
This is my driver wish. 84% and 85% pedal position are almost the same, because of the over boost from the Ford Focus:
363863
I have two torque limiter like the one below, set to identical values:
363865
And 7 others limiters which I knew are for each gear. All of them increased to 310 maximum:
363866
Also, another torque limiter with atmospheric pressure:
363867
The single value torque limiter is set to 350 (right before the 7 torque limiters).
However, on a test run with the pedal pushed 100% from 1500RPM to 3500RPM, the net engine torque from Forscan never went over 264.
Any ideas would be greatly appreciated!
I need your help with some issue that I have.
I'm trying to tune my Ford Focus, and increase the power to around 305Nm and 135Hp and also disable DPF (switch method) and EGR (hysteresis method).
Most of my tune works fine, however, I seem not to be able to go over 264Nm of requested torque (as read by Forscan) for some reason. I can surely feel an improvement and all the values (besides the net engine torque from the attached image) are correct in Forscan.
Test run:
363864
This is my driver wish. 84% and 85% pedal position are almost the same, because of the over boost from the Ford Focus:
363863
I have two torque limiter like the one below, set to identical values:
363865
And 7 others limiters which I knew are for each gear. All of them increased to 310 maximum:
363866
Also, another torque limiter with atmospheric pressure:
363867
The single value torque limiter is set to 350 (right before the 7 torque limiters).
However, on a test run with the pedal pushed 100% from 1500RPM to 3500RPM, the net engine torque from Forscan never went over 264.
Any ideas would be greatly appreciated!