PDA

View Full Version : jeep tj back pinout


Berubeg
26th March, 2016, 08:14 PM
tj with 68hc912B32 for digiprog with cable 51 no need to remove needle366136
Romanky
26th March, 2016, 08:30 PM
Digiprog 3 ?

motorola 912B32 disconnect the pins into boards.
Berubeg
26th March, 2016, 09:13 PM
Yes but with digiprog 3 procedure need to disasembly cluster not with pin out in my Link.
Romanky
26th March, 2016, 09:29 PM
Yes,,, dismantle some dashboards do not go OBD.
Berubeg
26th March, 2016, 09:58 PM
Yes with this just remove Back cover
Romanky
27th March, 2016, 12:38 AM
OK,, I knew it would not be so complicated.
mann357
14th April, 2022, 04:26 PM
Digiprog 3 ?

motorola 912B32 disconnect the pins into boards.

I have a digiprog3 and DSP3. For the digiprog3 I don't have 12v cable-51, But i do have 5v motorola cable-48. I need the 'picture' labled with the GND, 12V, BDM & RST..... Now on my DPS3 HC12 isn't available under wrangler but I do see HC12 under voyager, will it work? Thanks in advance.
apexseal
15th April, 2022, 12:57 AM
I might be wrong since I do not own a digiprog3 or dsp3 or use color codes but looking at that pinout seems like:

White = VCC
Brown = GND
Green = Reset
Yellow = BKGD
waltermanuel
15th April, 2022, 02:29 AM
the colors vary from one tab to another in my case red= reset_ brown=bkgd _black=5volt _orange=grund....881726..better check on the tab
apexseal
15th April, 2022, 04:51 AM
Yup... Always best to check your own configuration and forget about colors...