PEUGEOT 807 EDC15C2 DPF REMOVE PROBLEM

[securipro38]

Hi
I tried to remove dpf on peugeot 807 2006 edc15C2 whit ecusafe and volta software .
I read file with galletto V54 and car start but always dtc on screenboard
I tried file with swiftec file seem to be good but car don't start at all
Maybe problem is galletto checksum ?
I tried to check file with winols and it say that checksum block could not be identified
Can someone check these files for me please ?
File 1 original car start with error on screen
file 2 modified by ecusafe car start with error on screen
File 3 modified by swiftec car don't start

Thanks a lot

[lkjubaking]

here file for you

[bobolin4o]

Hi
I tried to remove dpf on peugeot 807 2006 edc15C2 whit ecusafe and volta software .
I read file with galletto V54 and car start but always dtc on screenboard
I tried file with swiftec file seem to be good but car don't start at all
Maybe problem is galletto checksum ?
I tried to check file with winols and it say that checksum block could not be identified
Can someone check these files for me please ?
File 1 original car start with error on screen
file 2 modified by ecusafe car start with error on screen
File 3 modified by swiftec car don't start

Thanks a lot

And what DTCs you have after Ecusafe file?

[Voltech90]

swiftec solution working on this ecu

[lkjubaking]

Hi
I tried to remove dpf on peugeot 807 2006 edc15C2 whit ecusafe and volta software .
I read file with galletto V54 and car start but always dtc on screenboard
I tried file with swiftec file seem to be good but car don't start at all
Maybe problem is galletto checksum ?
I tried to check file with winols and it say that checksum block could not be identified
Can someone check these files for me please ?
File 1 original car start with error on screen
file 2 modified by ecusafe car start with error on screen
File 3 modified by swiftec car don't start

Thanks a lot
You try my file ?

Послато са GT-I9505 уз помоћ Тапатока

[securipro38]

You try my file ?

Послато са GT-I9505 уз помоћ Тапатока
Hi
sorry I have the car tonight or tomorow ,I will report result when it done
Thanks a lot

[securipro38]

Hi lkjubaking (http://www.digital-kaos.co.uk/forums/member.php/360801-lkjubaking)
always same default ,can start ,I 'm going to change again parameters on bsi a post results

[spychu14]

Look - to use swiftech u have to use brain too. Checksum are not touched in swiftech file. U have errors because ecusafe didnt make them off but it calculate checksum :D Connect this two solutions in winols, then disable DPF in BSI and voila :)

[securipro38]

You try my file ?

Послато са GT-I9505 уз помоћ Тапатока

Hi ,
File worked thanks :stung: