need help with x prog m,how using it right with test clip etc.

[bob10]

Hi together,:)

for sure a stuiped question for you,but i dont know how to get this tool working:(

i try to read a eeprom(desolder) 24C32,i put my pomona test clip into the x prog (dip 8)see pictures,but it dont work.

i choose the right eeprom in x prog,but after i try to to read/write i got this message:

Device insertion error bad contact at pins 5,6,8 etc.

were are this pins?is it necassary to laying cabels +12/ground etc?
is there maybe a manual for beginner??

i work in the past with a chinese Mini Pro programmer,and with this is it not a problem to read in circuit a eeprom,not all but it works with some eeproms.

i hope you can help me a litte to understand my mistake?368688368689368690368691368692



thanks you very much for your help

best regards

bob10

[strikeforce2]

I read 95160 eeprom peugeot BSI yesterday and initially got device insertion error at pins 2, 3, 5, 7, 8. so I use a small knife to scrape on the pins to remove resin on the eeprom and I was able to read the chip. by the way make sure pin 1 is matched to pin 1.

[drz]

Bad clip. If you have adapter, solder eeprom on it and you will see that everything will be ok.

[bob10]

Hi,

Thanks for answers,but what Kind of a Test Clip you use Guys?
please Post a Photo.

i also try to turn the Test Clip,but the result was the Same.
and what also Strange is,if i put the Test Clip out from x prog i got the Same error??
why??x prog dont recognize the Test Clip??

i got also a eeprom Adapter,but how use this,is it Really necassary to solder this eeprom on this Adapter?
why so complicated,i thought x prog also can Read in Circuit:-(


my best regards

bob10

[joker01]

guys keep this old discussion .....
I have the same problem with my xprog 5.74.
if I use caliper pomona I always error pin 3 ???
same clamp with upa-s no problem.
someone can read e2p with pliers without desoldering ???
thank you.....