Immo off in VW 7N0920880J Dash

[stonecoldro]

Hello guys,

I was wondering if you can help me out with this cluster adaptation :-)

I have a used cluster I want to adapt it to my car, which is a MK5 Jetta. The cluster has P/N: 7N0920880J , SW0003, HW03

I only have access to the dump (see below), which needs to be immo off, because of key not found messages and beeps. Car starts, because it has immo off done before in ECU. Probably the KM would need to be inserted also which are about 126800km, but I'm not sure if that's possible via dump.

URL to original 24c64 dash dump: https://www.wetransfer.com/downloads/e2ce1835a587402ca0527b88c5f2837820160409141232/f14f8bba21597e79204c87601d11241620160409141232/6c5cd3

Any help is greatly appreciated.

Thank you
(https://www.wetransfer.com/downloads/e2ce1835a587402ca0527b88c5f2837820160409141232/f14f8bba21597e79204c87601d11241620160409141232/6c5cd3)

[ciptel07]

you need full read micronas CDC 32XX + eeprom

[stonecoldro]

you need full read micronas CDC 32XX + eeprom

not sure if it can handle it. this is a 09.2014 3D cluster :(

[stonecoldro]

Also I need to get rid of the "key not found" error in the dash after the engine is started

[lupu_sandu]

All via obd2 mate. Nothing via dump

[H2Deetoo]

First of all it's a NEC cluster with software version SW0003. There are no public tools which can handle these versions.

[stonecoldro]

Yep, so I read on other forums as well. @H2Deetoo clear your inbox mate, I tried to send you a PM :)

[H2Deetoo]

Inbox cleared.