PDA

View Full Version : Octavia2 pcr2.1 read error



yeager
10th April, 2016, 03:13 PM
hi
after i make unlock on ecu pcr2.1 and try read obd2 i always get read error, first on 98% second on 31% and finally on 77%. i disassemble again car and try read on table, but on first try i get same error on 87% ... second try was successfully
i need turn off egr, but have tire, that on write i again get error ... what will be happened then? i can try write more time until success?
thx

PS: car start without problem after unlock

honingkoning
10th April, 2016, 03:19 PM
hi
after i make unlock on ecu pcr2.1 and try read obd2 i always get read error, first on 98% second on 31% and finally on 77%. i disassemble again car and try read on table, but on first try i get same error on 87% ... second try was successfully
i need turn off egr, but have tire, that on write i again get error ... what will be happened then? i can try write more time until success?
thx

PS: car start without problem after unlock

Pls be more clear what tool u use,

did u use it earlier on pcr2.1?

Wbr Adam.

yeager
10th April, 2016, 03:37 PM
i use gal2 eu clone and make before without problem 10-20 pcr2.1 ...

yeager
10th April, 2016, 06:49 PM
ufff, it is so hard question?

kospoz
10th April, 2016, 08:37 PM
ufff, it is so hard question?

You must try more times i had same problem and got kess no problem at all

yeager
11th April, 2016, 05:57 AM
ok, so i can try whit gal2 write until success ...