View Full Version : Mercedes C200 W204 DCM3.2 BDM read
feti589
12th April, 2016, 06:48 AM
Hello,
I would like to read a DCM 3.2 from Mercedes c200 W204.
BDM100 seems to not support it because it's older than the car.
I have official trasdata, but not official delphi bdm probe.
Do you think that is compatible ? Is there any risk to try ?
You can find in attached files, pictures and pinout
Thanks for your help.
369108369109369110
wiski
12th April, 2016, 07:03 AM
Do you have original adapter? check pinouts if they are same with the probe then you can use it if not just solder it. Be carefull it is delphi reversed for this ecu.
Sent from my SM-A510F using Tapatalk
feti589
12th April, 2016, 07:14 AM
Do you have original adapter? check pinouts if they are same with the probe then you can use it if not just solder it. Be carefull it is delphi reversed for this ecu.
Sent from my SM-A510F using Tapatalk
I do not have original dimsport probe.
I put you a picture of original compared to mine..
Yes delphi reversed that why I do not want to do a mistake and take the risk of try
369114
wiski
12th April, 2016, 07:17 AM
Didn't this adapter came with your tool? http://www.tuningfiles.com/14as00t04s-k-tag-adapter-for-delphi-dcm-ecu-motorola-mpc5xx.html
Sent from my SM-A510F using Tapatalk
feti589
12th April, 2016, 07:31 AM
Ok, will check If I have it..
Found this : (on bdm100 original documentation)
369116
feti589
12th April, 2016, 01:00 PM
I have this adapter with trasdata..
I have to compare pinout with my delphi prob
If it's not match I will solder this adapter on pcb
But pcb seems to have varnish on it.. is it easy to solder ?
369183
wiski
12th April, 2016, 04:38 PM
Sure it's easy :)
Sent from my SM-A510F using Tapatalk
feti589
19th April, 2016, 02:02 PM
Sure it's easy :)
Sent from my SM-A510F using Tapatalk
Feedback
Read and Wrote with adapter soldered on
Thanks for your help
wiski
19th April, 2016, 07:52 PM
Great :)
Sent from my SM-A510F using Tapatalk
rtw
15th October, 2016, 09:02 PM
It is 646evo CRD11?
wiski
16th October, 2016, 10:01 AM
Yes
Sent from my SM-A510F using Tapatalk
DjRomeoR
16th November, 2018, 03:06 PM
I have this adapter with trasdata..
I have to compare pinout with my delphi prob
If it's not match I will solder this adapter on pcb
But pcb seems to have varnish on it.. is it easy to solder ?
369183
I soldered like in photo with K-tag tryed read ,but have error : Hardware not supported"
What mean in photo this Black and Red wire , it's extra power ore it's for led ore button wiring ?
bersch8688
16th November, 2018, 08:02 PM
The RED circle is 12V Power cable on adapter ;-)
But it is enough when you give 12V on the ECU Pinout ;-)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.