Vectra C/Signum Dash on bench - how to connect

[stachu22]

Hello. I need to connect Vectra C cluster on bench. I found info that:
PIN 1 - GND
PIN 4 - +12
PIN 5 - CAN H
PIN 6 - CAN L

I need any CAN emulator for it? If i connect power supply there only clues move a little bit...


I don't find info in http://www.digital-kaos.co.uk/forums/showthread.php/228391-Power-Up-Collection :(

[Cardiag.ru]

Vectra C use single-wire CAN.
Yes, it need IGN ON command in CAN-bus

[stachu22]

Thank you. Can you tell me, can I have this signal if I connect CIM module to Dash Via can?