No Channels After Scanning

[eirebadboy]

I just got my Starview 4 today, I installed firmware 1.12, scanned the channels but none were found. I turned the key on and scanned again and still nothing - not one single channel or radio station.
I was previously using the old General Instruments box which was working okay.
Living in Northern Ireland and receiving an analogue signal.
Any advice on manually scanning or anything else much appreciated - otherwise there is a brand new Starview 4 box for sale.

[caveman_nige]

who is your cable supplier?

[eirebadboy]

Virgin Media (N*L) - I have broadband with them.

[caveman_nige]

ok, have you had a read through this..
http://www.digital-kaos.co.uk/forums/f83/its-here-idiots-guide-starview-4-initial-setup-30784/

[eirebadboy]

Yeah, followed it strictly step-by-step except used firmware 1.12 instead of the 1.07 mentioned in the guide.
I'm baffled as the old analogue General Instruments box picks up the channels okay.
Cheers for the help Nige, appreciated.

System info:

C500
1.12
b-11

[caveman_nige]

Ok... I do not have one of these boxes so will let one the starview guys take up the thread for you and get you sorted..

[martin-f]

otherwise there is a brand new Starview 4 box for sale.
thats your best bet m8 irl is all going/gone to nag 3 no fix for this ATM or near future there are still of use in the uk

[cactikid]

are you selecting n and auto scan,

[Evastar]

It should work if you are in Northern Ireland, n3 isn't out there.

[dk002]

Did you pick your provider you never said and check your connection the rest sounds right

[ritter1974]

:argh: avin same prob mmmmmmmmmmmmmmmmmmmmm8