Kia 95910-2P580 ver 1.2 G58 crash

[andreimrus]

Hi
can someone clear this file Kia 95910-2P580 SAH-XC2361A-72
Thanks.
371268

[andreimrus]

Hi,
I need help.
I found a clean dump, corrected VIN,
but crash was gone, but there was a mistake ABS. 382089

today, I correct my crash dump (Related above.) 382090
check to see if I properly cleaned?

Thank you

[credoline]

Not good. Use this link to check your dump:
http://www.codecard.lt/MAC/index.php?code=hyundai

[andreimrus]

I corrected dump, that's what happened,
I checked the link, no errors, will be tested car.
382161

[alismotors]

Original dump :ECU identifier block:
[62374830000004647314/02/102PFWZZ2A120377]
ECU error block 00009280:
B1650 Crash recorded in Stage only
B1620 Internal fault- Replace the ACU
B1329 FIS Driver communication error
B1334 FIS Passenger communication error
B1742 P-SIS Front Driver communication error
B1748 P-SIS Front Passenger communication error
B1412 SIS(Side Impact Sensor)Rear-Driver Communication error
B1413 SIS(Side Impact Sensor)Rear-Passenger Communication error
B1527 Passenger Airbag on-off switch open or short to Battery
B2500 SRS Warning lamp Failure
B1378 Side airbag front-Driver resistance too high
B1382 Side airbag front-Passenger resistance too high

file without crash :))) ECU error block 00008980:
B1650 Crash recorded in Stage only
B1329 FIS Driver communication error
B1334 FIS Passenger communication error

[credoline]

If yours file not work (i think will not work ok) try with my file.

[andreimrus]

alismotors (http://www.digital-kaos.co.uk/forums/member.php/446490-alismotors)

file without crash :))) ECU error block 00008980:
B1650 Crash recorded in Stage only
B1329 FIS Driver communication error
B1334 FIS Passenger communication error

Have I made a mistake. may file should look like this..382219

credoline (http://www.digital-kaos.co.uk/forums/member.php/89856-credoline)
thanks, I'll try.

[credoline]

This file you are upload is, when i check him with one software, without crash data, but with my experience will not work. But try it.

[alismotors]

file without-info-crash-2 :
ECU identifier block:
[62374830000004647314/02/102PFWZZ2A120377]
ECU error block 00008280:
No DTC
ECU error block 00008680:
No DTC
ECU error block 00008980:
No DTC

[andreimrus]

Today could not be tested, I checked only at the end of the week.

[andreimrus]

Today I tested.
This file is not operating.
(http://www.digital-kaos.co.uk/forums/member.php/89856-credoline)
95910-2P580 XC2361A-72 clear G.rar

code B1620 B1650 B1684.

I made a new dump. 382930,
tested.... All good.
but in abs I got an error C1285,
I had to calibrate the G sensor.

Thank you all for your help.

[khching2003]

u use wat programmer to read ?