PDA

View Full Version : Renault Truck Kessv2 " ECU in curfew "



zizouth
22nd April, 2016, 07:00 PM
Hello,

I try to read Renault truck Prenium 440 DX1i with original Kess V2 .
When I try to read or ID , I have message after while "ECU in Curfew" in k-suite.
After call Alientech they said to make this procedure :
In dachbord -> Expert -> diagnostic -> Calibration ID -> enter a value -> "Data Trasfert"-> wait error message , After that kess can communicate with ECU (Do not switch off dahbord).

The problem is that I can't enter a value. When I click to calibration ID , I have directly "Data tansfert" then the error . And same problem with Ksuite when I try to ID.

PS : I use the right renault truck cable

Anyone meet the problem please, and what is the solution?

Thank's for help

ed209trucks
24th April, 2016, 07:09 PM
i had the same problem on a volvo.

start the engine, let run for 5 minutes then id it while it is still running.

should access the ecu.

zizouth
25th April, 2016, 06:50 AM
Will try Thx!!

For reading/writing, should shut off engine?

ed209trucks
25th April, 2016, 12:07 PM
Will try Thx!!

For reading/writing, should shut off engine?

yes only id when engine is running.
:burnout:
dont forget to hit thanks if this helped you

ed209trucks
11th May, 2016, 10:41 PM
did this work for you??

zizouth
12th May, 2016, 06:50 AM
Hello,

I try everything without result :
Wait ignition on 5 minute
Wait ignition on 20 minute
Id when Ee start
Id when Engine start after 5 min

always ECU in Curfew :(

As I see it is a protocol problem because when I try another protocol (volvo) same problem.

Thx

ed209trucks
15th May, 2016, 11:10 PM
mine is original kess and alientech told me the same thing, go into dashboard ect,ect, this also did not work for me.

then i found out, switch the engine on then id, this has worked for me on 4 volvo`s now.

telephone alientech they should sort it out for you if you think you have a protocol problem.

thx.