Help read fiat stilo ME73H4F015 with galleto 1260 [Sitemap]

View Full Version : Help read fiat stilo ME73H4F015 with galleto 1260

philipcoin

29th April, 2016, 05:12 PM

hello mate i have fiat stilo want to read ecu with galleto1260 but asking for boot
please can some help with pinout including boo to read ecu.

ECU NUMBER - ME73H4F015

thanks regards.

Tuiken

29th April, 2016, 05:31 PM

Here matehttp://uploads.tapatalk-cdn.com/20160429/6218967e4b5e29c0e60fa43a22f66edc.jpg

If help press thanks

philipcoin

29th April, 2016, 06:25 PM

thanks mate
follow your picture but get BOOT MODE INACTIVE
how can i by pass this...........
thanks

yellowstilo

29th April, 2016, 07:25 PM

connect ground + pin 18 ( + 12v direct)
connect k-line
connect boot pin to ground
after that power on +12v (switched !) pins 17 - 33 - 49 and 51.
now you should be able to read the ecu in boot mode.

to repeat - disconnect boot pin + switched +12v wires, reconnect boot pin, then reconnect switched power to get into boot mode again.

philipcoin

29th April, 2016, 08:02 PM

THANKS MATE

WILL TEST AND REPORT.....

philipcoin

29th April, 2016, 08:21 PM

Having hard time reading this ecu

very hard to to wake boot mode

still boot mode inactive

Tuiken

29th April, 2016, 08:24 PM

Maybe the ECU is not good
If you have another tool try

Enviado do meu iPhone usando o Tapatalk

philipcoin

29th April, 2016, 08:27 PM

ok will try different ecu

thanks

philipcoin

30th April, 2016, 12:23 PM

[QUOTE=Tuiken;2758804]Maybe the ECU is not good
If you have another tool try

got different ecu
still saying BOOT MODE INACTIVE

it says
ATTENTION BEFORE TO READING AND WRITE- REMOVE FEEDING PUT PIN20 ECU TO MASS,GIVE FEEDING END TO CONTINUE.SEE THE PDF FILE INFOLDER DOCUMENT.

Tuiken

30th April, 2016, 01:54 PM

First gnd to boot pin and after power ON the ECU

Enviado do meu iPhone usando o Tapatalk

yellowstilo

1st May, 2016, 07:38 AM

as i explained before - connect permanent power wire , k-line + ground, then connect boot wire, then connect the switched power wires (4x) - ecu is in boot mode now....

" connect ground + pin 18 ( + 12v direct)
connect k-line
connect boot pin to ground
after that power on +12v (switched !) pins 17 - 33 - 49 and 51.
now you should be able to read the ecu in boot mode.

to repeat - disconnect boot pin + switched +12v wires, reconnect boot pin, then reconnect switched power to get into boot mode again. "