X5 BMW E70

[magicworx]

Hi guys
Having a problem with this car.Came in lost keys. Did key from cas3+ took DDE dump and loaded to Tango.
Car cranks,no start. ECU No.0281015240 DDE7810950.All parts are original(or so says customer,im the third person to work on it!).
Fault codes 4A62 and 4A63 ews tampering.Tried sync with FVDI and Launch Pro with no luck.373722I get incorrect start values.I've attached ecu and cas dumps.Could someone please have a look and help me? Vehicle is 2010 BMW X5 3.0xdrive.

Thanks in advance
If it helps: cas no.61.35-9147217-01

[magicworx]

Hi.Could someone perhaps just check and give me ISN numbers please? Much appreciated.
Thanks

[PremierD]

Ecu one comes with error .. but Cas is good ( I think) lol 123and 5 used ..

[magicworx]

Thanks PremierD.Is there any way for me to correct it?

[PremierD]

Bram is your man mate ..

[lupu_sandu]

CAS3+ ISN long 16bytes, encrypted.

[magicworx]

Thanks Lupu_sandu.Please i need help to repair? Any suggestions?

[bearheroes]

cas3+ just encrypted...not necessary 128bit isn...try tmpro...car will start for sure... :)

[fast7850]

if the car crank that mean the key is ok you must use diagnostic to synchronisation cas and ecu

[magicworx]

@fast7850 read post #1! Tried sync with FVDI and Launch. Bearheroes should i make new transponder with TMpro wit original info?
Thanks.

[bearheroes]

ori cas dump and ori ecu dump.

[magicworx]

Hi all
Done key with Tmpro car cranks but no start.Can someone give me ISN of cas and DME please?And where to change isn, in cas or dme?
Please guys i need help with this vehicle!
Thanks in advance

[bearheroes]

Try to sync with any tool...avdi, inpa etc...


Sent from my iPhone using Tapatalk

[geeroam]

Have you managed to solve? Have same problem with e90?