Mx3Speed
11th May, 2016, 11:39 AM
Hi, a friend just bought a tu5jp4 1.6 16v bosch ecu to swap it on a Talbot. We need to remove the most part of ~~~~ wired to ecu harness, only need that engine starts. The rest of wiring loom will be a mix between engine wiring & talbot wiring. No BSI, cluster, etc.. needed.
I have been reading about immo off on me 7.4.4, but it's not clear enough to me the correct procedure. I understand that the only eeprom i need to desoldering and read & rewrite it's the 25c16 8 pin at the top of the right side. i'm right?
http://i275.photobucket.com/albums/jj295/Mx3Speed/WhatsApp-Image-20160511%201_zpsstk0mvz2.jpg
Just disabling immo we would get start the engine without the other accessories? I'm so ~~~~ing lost :'(.
Someone can help me a little bit, please? Thx
Oh, and excuse my english...
I have been reading about immo off on me 7.4.4, but it's not clear enough to me the correct procedure. I understand that the only eeprom i need to desoldering and read & rewrite it's the 25c16 8 pin at the top of the right side. i'm right?
http://i275.photobucket.com/albums/jj295/Mx3Speed/WhatsApp-Image-20160511%201_zpsstk0mvz2.jpg
Just disabling immo we would get start the engine without the other accessories? I'm so ~~~~ing lost :'(.
Someone can help me a little bit, please? Thx
Oh, and excuse my english...