View Full Version : MB sprinter "902 " 216cdi Limp mode
mexanico1971
13th May, 2016, 12:39 PM
Hi !
Got this 2.7cdi engine width P1470-008 " boost controller " Low voltage "
Wires 48 and 35 checked
The problem is GND from ECU ; I open the ECU and inspected , no solders or damage sins !
And other problem , Star cant comunicade width sprintshift ECU !
can any one tell me what this relays are ?!
Thank"s in advance
Brs
mexanico1971
20th May, 2016, 02:27 PM
Hi !update !
I manege to get diag width Sprintshift ecu , MB dealer don"t :hmmmm2: !
Solution was clean pins of the round sprinter DLC connector lol
But I found one PIC , on "google" like the one I have in previous post but Relay positions are different !
Is this correct ??
Thank"s in advance
BRS
mexanico1971
31st May, 2016, 01:01 PM
HI !
Know one face this problem before ?!
Sprintshift gear box DTC"s
P2080--hydraulic pressure low
P2054 pump relay
P2012- door swicth
P2045-004 --CAN message from instruments
only take out gears wend is slowing !
BRs
mexanico1971
20th July, 2016, 08:13 PM
Hey !
No one knows nothing about Sprinter ~~~~ ?!
fat660
1st August, 2016, 09:28 PM
389767
here is YOUR relay for sprintshift pump, if it`s bad it can give You pump/pressure faults
there is also 40A orange fuse under driver`s seat for pump.
what`s the pressure at idle? post screenshots of actual values from star
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.