kingarthas
15th May, 2016, 12:33 AM
I`m planinig to read/write EDC17c19, and I found quite a lot people ask for help to revive EDC17 after flash.
Kindly request you to give some tips on reading/flashing procedure for EDC17 to avoid bricks.
What I found till the moment:
1) Remove ECU form the car - no info about battery should it be connected or disconnection?
2) Do not lock the car prior ECU disconnection
3) Before removal ensure all electrical equipment in the car is off
4) Remove the key from the car
5) Ensure the car is in neutral or parking
6) While ECU Is removed do not try or switch on/off any equipment, open/close doors, lock/unlock car
7) After pry open EDC reconnect and try to start the car before programing
8) Do not flash EEPROM
9) At least do not flash the car with EEPROM read where car is started between read and write - Should this apply for internal flash?
Any tips are appreciated...
Kindly request you to give some tips on reading/flashing procedure for EDC17 to avoid bricks.
What I found till the moment:
1) Remove ECU form the car - no info about battery should it be connected or disconnection?
2) Do not lock the car prior ECU disconnection
3) Before removal ensure all electrical equipment in the car is off
4) Remove the key from the car
5) Ensure the car is in neutral or parking
6) While ECU Is removed do not try or switch on/off any equipment, open/close doors, lock/unlock car
7) After pry open EDC reconnect and try to start the car before programing
8) Do not flash EEPROM
9) At least do not flash the car with EEPROM read where car is started between read and write - Should this apply for internal flash?
Any tips are appreciated...