PDA

View Full Version : VW LT35 0281011385 IMMO OFF


shafo
23rd May, 2016, 11:36 AM
Hi Guys
this vehicle came to my shop in a terrible state..vehicle non starting and I suspect the immo is the main issue
I stripped the ecu out and found the 24c04 eeprom had been removed by someone before..i removed eeprom and I read
eeprom is blank :(
does anybody have a complete immo off dump for me

eeprom 24c04
ecu- 074906018BK
bosch-0281011385
edc15vm+
lt35 2.5

many thanx
Shafo
dragon100
23rd May, 2016, 11:44 AM
Hi, try this and report, don't forget about reputation+thanks.
shafo
24th May, 2016, 03:31 PM
Hi, try this and report, don't forget about reputation+thanks.

hi buddy ! i tried this and vehicle starts and cuts out..any other immo off dumps guys?
dragon100
25th May, 2016, 06:52 AM
What errors do you have ?
shafo
25th May, 2016, 01:05 PM
that's the funny part..i only hAve a glowplug fault ..no immo faults on ecu...obviously on immobiliser 17 I have faults of key but I assume with immo off that shouldn't matter...should I unplug immo box?
dragon100
25th May, 2016, 01:22 PM
disconnect and try ...
shafo
8th June, 2016, 12:14 PM
disconnect and try ...

thank you!! your immo off file works perfectly..the reason my bus still cut out was because of a fuel delivery issue!!!
catagoe
21st June, 2016, 09:06 PM
Hi,
I'm disturbing you with a beginner's question :

Where can I find on the PCB of ECU 074906018BK the eeprom 24c04 ?
Thanks in advance for your feedback !
shafo
24th June, 2016, 06:22 PM
Post a picture and I can show u
catagoe
27th June, 2016, 09:08 PM
here us a picture 383626
Thanks in advance for your feedback !
shafo
28th June, 2016, 08:41 PM
It's the eeprom on top of Picture next to 29f400 friend..think it says ST95P08?
catagoe
1st July, 2016, 11:42 PM
Hi Friends,

I'm having another problem:

From the original ECU from the VW LT, I took out the 24C04 component and put it on the new ECU.
So far, ok, the immo lamp is not flashing anymore. Unfortunately, the car still doesn't want to start.
After a short check, on ECU I can see following error code present :

18020 - Engine Control Module Incorrectly Coded
P1612 - 35-00 - -

Also, the Shop code looks strange :

Shop #: WSC 00000

Any hints / tips are very welcome !

PS: the old ECU is "dead" . Is not accessible anymore.

Thank you all !
kardesler27
30th December, 2020, 11:19 AM
teşekurler