Atmel AT91SAM7S64 J-link

[vanos batam]

anyone have Bin file Atmel AT91SAM7S64 Jtag-link(j-link)
bestregard

[stas12]

377216try this bin.

[vanos batam]

anyone have Bin file Atmel AT91SAM7S64 Jtag-link(j-link)
bestregard

Same device can use?
Any connection pin diagram programing jlink to jlink
Thanks

[stas12]

...use samba to write,is easy way.Insert jetlink in usb and short jumper (erase) for 30 sec,disconect from usb,reinsert,short jumper(tst) for 10 sec-now reinsert and jetlink recognize as samba development board,now whith samba software write bin.

[mecale]

1) Install SAM-BA http://www.atmel.com/forms/software-download.aspx?target=tcm:26-78558
2) Open J-Link Case
3) Identify ERASE and TST Jumpers
4) Close Jumper "ERASE" and pluggin Jlink to USB port, and wait for > 1 min and remove USB connection
5) Close Jumper "TST" and pluggin Jlink to USB port, and wait for > 1 min and remove USB connection
6) Make sure that ERASE and TST jumpers removed and pluggin Jlink to USB port
7) Now deivce will be identified as Virtual Serial port (USB-Serial adaptor), if fails follow steps 3 to 6 again till you get USB-Serial adaptor in device manager.
8 ) After getting step 7, start SAM-BA and select COM port assigned to Jlink, and board as "AT91SAM7S64-EK" and then click connect,
9) Select .bin file in FLASH tab and click send file http://www.digital-kaos.co.uk/forums/attachment.php?attachmentid=377216&d=1464029117
10) You will be prompted with Do you want to unlock involved lock region(s) (0 to 15)? "Yes" to unlock it., -> Select YES (pic3.jpg)
11) You will be prompted with Do you want to lock involved lock region(s) (0 to 15)? "Yes" to lock it., -> Select NO (pic4.jpg)
12) You are done :-) ..... Happy Coding...

[robarago]

Thank you very much for posting this info.