mokjemai
28th May, 2016, 12:39 AM
Dear friends,
I have one MDEC ECU connected with one PIM via CAN bus and used for a standby generator.
I replaced the MDEC with new one and install back the old EPROM's but after powering up the whole system I still can't start the engine and got the "TALK" message on the MDEC internal display.
I contacted the specialists from MTU and they advice me to load the ecu and pim files via CAN network.
I'm not really familiar with those equipments and I have the software and I'm going to made a cable for communication with PC Diasys but I would like to know which files I need to load to the mdec and where I can find them and is there any precaution to avoid ereasing my EPROM's.
If you got any manual for MDEC and PIM programming kindly share it with me
I need to sort out my issue ASAP
I appreciate your support to get this issue resolved
Look ahead to hear from you guys
Best Regards
I have one MDEC ECU connected with one PIM via CAN bus and used for a standby generator.
I replaced the MDEC with new one and install back the old EPROM's but after powering up the whole system I still can't start the engine and got the "TALK" message on the MDEC internal display.
I contacted the specialists from MTU and they advice me to load the ecu and pim files via CAN network.
I'm not really familiar with those equipments and I have the software and I'm going to made a cable for communication with PC Diasys but I would like to know which files I need to load to the mdec and where I can find them and is there any precaution to avoid ereasing my EPROM's.
If you got any manual for MDEC and PIM programming kindly share it with me
I need to sort out my issue ASAP
I appreciate your support to get this issue resolved
Look ahead to hear from you guys
Best Regards