View Full Version : chevrolet DCM3.7 vs FGtech-54

1st June, 2016, 10:12 PM
hi to all!!
reading went well, when writing write error,
connection according to the instructions, but I am embarrassed by the link 1, it connects the mass to the mass, although they are connected by the board so ... this is the right connection here or a mistake?
Thank you!!!378987

23rd February, 2017, 09:02 PM
hi friends problem equal boot error pőlease help

23rd February, 2017, 09:37 PM
FGtech clone china not work with this ecu!

14th April, 2017, 07:21 AM
How about Kess Clone v2 2.11 firm. 4.036? Ive seen this ecu beeing read with this tool but ORI HW made from Slave into MAster working with this craked 2.11. No sure if clone does it