Scenic diesel immo off

[locks85]

Hello
I cleared immo and used emulator, inside ecu 24c02 , one plug on ecu
Car started and worked fine for 1 week
After that it wouldnt . So i removed ecu and cleared immo again, used same emulator that i bought from codecard
Car starts fine but i must find out why it stoped after a week and what to do not to stop again .
Regards
Locks85

[Brolk]

hello

removig 24c02 starts ??

Brolk...

[locks85]

Hi i didnt try because i think i tried before on a jeep and there was no acceleration
Plus car is not here
rgards

[Brolk]

It is limited to 3000 rpm ..

inmo off solution

Brolk..

[metercar]

ECU number?...

[locks85]

bosch 0281010077 thanks in advance
regards
locks85

[Brolk]

http://www.digital-kaos.co.uk/forums/showthread.php/457742-0281010077-immo-off

I found

Brolk..

[locks85]

Yes but it says
Work with Bosch MSA 15.5 without pression sensor inside.
I dont know if my ecu has this sensor . Ofcourse i can try, worst case senario it will start and mil will blink plus it wont save fault codes ??
regards
Locks85

[furnata]

Easy to remove immo in 24c02 - just post eeprom conntent here then change with new 24c02 WP and cut 59 pin from ecu

[locks85]

Any specific tested 24c02 suitable for write protect ? Write protect is nesecary if i cut the wire ?
regards
locks85

[mb7361]

never work !!!