PDA

View Full Version : Marelli MJD pinout for BDM



AnixoR
17th June, 2016, 06:41 AM
Hi!

I need pinout for BDM read Marelli MJD6f3 for FGtech or ktag..

Thanks!

centrohifi
17th June, 2016, 07:01 AM
Friend, the CD or DVD software you have the PDF with the instructions, or use google and search pdf

AnixoR
17th June, 2016, 07:20 AM
I have PDF but on pic is conection with probe, i dont have it and need solder..

carmageddon
17th June, 2016, 08:15 AM
Hi!

I need pinout for BDM read Marelli MJD6f3 for FGtech or ktag..

Thanks!

this is for 6jf and 6f3

https://s32.postimg.org/oold8p80x/BDM_MARELLI_6_JF_6_F3.jpg (https://postimg.org/image/oold8p80x/)

AnixoR
17th June, 2016, 08:24 AM
i dont have probe..

can i connect like this on ecu board?

381811

Tes1a
17th June, 2016, 10:20 AM
yes that is good pinout

spychu14
17th June, 2016, 10:39 AM
With that pinout everything works with galletto. Remember about resistor and galletto cannot make chk on this ecu. All changes must be made with winols and checksum corrected.

AnixoR
17th June, 2016, 04:59 PM
I made full read ok with this pinout..

Thanks

cawadany
15th July, 2016, 09:32 AM
i dont have probe..

can i connect like this on ecu board?

381811

The GND in bdm port on ecu is not in correct position in this pinout. GND is next to pin 1.

Mario3
15th July, 2016, 10:23 AM
The GND in bdm port on ecu is not in correct position in this pinout. GND is next to pin 1.
Correct, and the one on pic. On every bdm port with mpc5xx, pin 3&5 are both grounds and connected together. So pic is good

Sent from my SM-N9208 using Tapatalk

cawadany
15th July, 2016, 10:42 AM
Correct, and the one on pic. On every bdm port with mpc5xx, pin 3&5 are both grounds and connected together. So pic is good

Sent from my SM-N9208 using Tapatalk

Ok, I understand. Thanks for explanation.