luca22
24th June, 2016, 11:33 PM
Hello Friends :)
My friend tried to program Crafter 2.5tdi on the OBD connector using Galletto V54 EU.
Unfortunately, record ECU was interrupted for 4%
I downloaded for Him from the base ECU original version BDM driver to put on the table, but after programming the car started normaly, but could not turn it off ...
The key removed from the ignition, and the Crafter engine continue working ???
After the suppression of the car gearbox for the second time does not ignite(started), but after disconnecting clamp on battery power for a few seconds lights up again and the situation repeats itself
He may be someone the same problem ??
Can anyone help with this problem ...
I tried to merge the file read the OBD to file BDM read out after blowing flash with success, but the situation is the same ...
Please help :)
Regards
Luca
383256
383257
383258
383260
My friend tried to program Crafter 2.5tdi on the OBD connector using Galletto V54 EU.
Unfortunately, record ECU was interrupted for 4%
I downloaded for Him from the base ECU original version BDM driver to put on the table, but after programming the car started normaly, but could not turn it off ...
The key removed from the ignition, and the Crafter engine continue working ???
After the suppression of the car gearbox for the second time does not ignite(started), but after disconnecting clamp on battery power for a few seconds lights up again and the situation repeats itself
He may be someone the same problem ??
Can anyone help with this problem ...
I tried to merge the file read the OBD to file BDM read out after blowing flash with success, but the situation is the same ...
Please help :)
Regards
Luca
383256
383257
383258
383260