View Full Version : pin from bsi Citroen c3
lush29
29th June, 2016, 06:32 PM
hi all, i need help with pin from bsi e0200 mg, citroen c3.
thanks in advice
Gavra
29th June, 2016, 06:42 PM
66TD or reverse
lush29
29th June, 2016, 06:54 PM
thanks a mill Gavra, i will test and report back.
btw anyone did replace this bsi without car? i mean from ori to donor? if i swap mcu and eep will work>?
Brolk
29th June, 2016, 07:01 PM
hello
DT66
Brolk..
Brolk
29th June, 2016, 07:48 PM
66TD or reverse
PHOTOS BSI,LABEL..
sometimes only the eprom
Brolk..
baltazar3
29th June, 2016, 08:05 PM
thanks a mill Gavra, i will test and report back.
btw anyone did replace this bsi without car? i mean from ori to donor? if i swap mcu and eep will work>?
without car You need a lot of luck.With car,fill e2p with FF and make telecoding with LEXIA
Zmann
30th June, 2016, 02:30 AM
How people can rely on BSI label, when after dealer (?) has updated the sw.
lush29
30th June, 2016, 09:34 PM
Sorted by coding. Thanks for your help m8. I was asking if can do on the table because i got few phone calls in past with car far away and i was thinking if is possible. Thanks again
Sent from my SM-G925F using Tapatalk
Brolk
1st July, 2016, 12:02 AM
Scaner to know if you can and software labes are equal
Brolk..
Zmann
1st July, 2016, 03:13 AM
Scaner to know if you can and software labes are equal
Brolk..
Yes, but that's not the same thing as when saying 'read label'. Anyway an inconvenience is to need putting donor BSI in too for the same reading :) then a bonus of mileage job if not zeroing first!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.