GolfmkI
14th July, 2016, 07:42 AM
I have Ecu Simos 9.1 POlo 1.2
It fails cyl 3 (misfire), it is not HW problem.
I tried cloning in other ecu ( same HW but diff Sw), then I discover that problem is in Sw.
When I load original Sw in donor Ecu car misfires again. If a let Sw in Donor Ecu as it comes car runs good but it stores many error due to Sw differences.
I need any full dump to load it (bootmode galletto)
I tried updating with Odis but it doesnt start update ( I used it many times), so I need to update Ecu this way.
Ver.HW: SIMOS91 1.2l
SW act.: 03E906023D 9510
5wp40502
It is not problem what sw is, but at least than reference is the same.
Or if is there any way to traslate .sgo file to .bin file so I can load it with galletto ( Odis fails)
Thanks beforehand
It fails cyl 3 (misfire), it is not HW problem.
I tried cloning in other ecu ( same HW but diff Sw), then I discover that problem is in Sw.
When I load original Sw in donor Ecu car misfires again. If a let Sw in Donor Ecu as it comes car runs good but it stores many error due to Sw differences.
I need any full dump to load it (bootmode galletto)
I tried updating with Odis but it doesnt start update ( I used it many times), so I need to update Ecu this way.
Ver.HW: SIMOS91 1.2l
SW act.: 03E906023D 9510
5wp40502
It is not problem what sw is, but at least than reference is the same.
Or if is there any way to traslate .sgo file to .bin file so I can load it with galletto ( Odis fails)
Thanks beforehand