Ruddyrum
4th September, 2009, 10:13 AM
Ok, so i have been having loads of troubles using my motor with my dm800! At first it didn't move at all, but that turns out it was a psu issues.
So the problem now is when i tell the dm800 to goto 0 it always goes about 10-15 degrees east of south! If i do a manual reset on the dish (align the dish with true south) and then tell the box to goto 0, it will go all the way east, and then park itself on 10-15 degrees east of south again!!
Often, manually moving the dish easet/west with the remote does not work, however when i tell the dm800 to goto 0 again, it does its usual trick!!!
Any ideas?
Thanks
So the problem now is when i tell the dm800 to goto 0 it always goes about 10-15 degrees east of south! If i do a manual reset on the dish (align the dish with true south) and then tell the box to goto 0, it will go all the way east, and then park itself on 10-15 degrees east of south again!!
Often, manually moving the dish easet/west with the remote does not work, however when i tell the dm800 to goto 0 again, it does its usual trick!!!
Any ideas?
Thanks