DTC P010F FORD C-MAX

[Romaus]

Hello all DK. I have a ford c-max 2007 1.8tdci siemens sid ecu. Car was a very smoked and show "engine default" on dashboard but don't light "checkengine" when accelerate.... i read fault by ELM327 - and have P010F.... i writing in ecu new file with egroff mod(method find on this forum )..... now car don't smoke, but when i accelerate and load engine about 2500-2800 rpm - also (like before egroff) dashboard show "engine default" and "checkengine" don't light(fault - p010f).... i was data read by elm on idle rpm ( stock ecu - boost 102 kpa... mass air flow - about 6,7 g/s..... egroff - mass air flow - 13,9 g/s boost like stock )..... when i accelerate ant test engine - max boost 228 kpa - on stock and 230 - on egroff - so i think boost work good.... mass air flow also show like work good.... may be me need dtcoff 010f ???? somebody can help do this ???? or may be method egroff incorrect ??? help please..... thanks
p.s. i attathed stock and mod file

[kumbari]

Reprogram ecu , on ford and mazda eeprom corrupted when readed by obd tool , need bdm tool ! I have the same problem with ford and mazda and finally i solved by reprogramming ecu with vcm ids ! If you read ford or mazda with edc16c34 after finish reading turn off for 10min and open and leave again 10 min ignition !

[mariusica_boy]

Hello all DK. I have a ford c-max 2007 1.8tdci siemens sid ecu. Car was a very smoked and show "engine default" on dashboard but don't light "checkengine" when accelerate.... i read fault by ELM327 - and have P010F.... i writing in ecu new file with egroff mod(method find on this forum )..... now car don't smoke, but when i accelerate and load engine about 2500-2800 rpm - also (like before egroff) dashboard show "engine default" and "checkengine" don't light(fault - p010f).... i was data read by elm on idle rpm ( stock ecu - boost 102 kpa... mass air flow - about 6,7 g/s..... egroff - mass air flow - 13,9 g/s boost like stock )..... when i accelerate ant test engine - max boost 228 kpa - on stock and 230 - on egroff - so i think boost work good.... mass air flow also show like work good.... may be me need dtcoff 010f ???? somebody can help do this ???? or may be method egroff incorrect ??? help please..... thanks
p.s. i attathed stock and mod file

Try my file.

[Romaus]

thanks.... i reprogram with your mod and test accelerate under load for engine.... now "engine default" don't show on dashboard also don't any dtc by ELM327..... so i use car everyday and i will test..... if something will wrong i report...... now all good

[mariusica_boy]

Welcome.
I'm glad for u.