Ford ka 2011 51889814

[bubbles69]

Ford ka 2011 51889814

please can someone clear

regards

[dragon100]

Try and report.

[Seselis5]

here you file
try and reply
pass in pm

[bubbles69]

1st file posted did not work trying second posted file now thanks

[bubbles69]

still no joy programed second dump and airbag light on diag shows 3 faults but wont clear scanner just hangs on clearing?>?

[dragon100]

What errors in srs unit ?

[bubbles69]

thanks for speedy reply

U0F81
B0F81
C0C81

all say pls refer to manual as code description

ive googled them and cant find any info im stumped here

[dragon100]

What diagnostic equipment did you use ?

[bubbles69]

launch bluetooth diagun 3, its a good scanner it is unuasal codes the srs is showing but wont clear so there somewhere in dump that wont erase

[dragon100]

Try this file and report.

[bubbles69]

ok thanks give me 20 mins

[bubbles69]

on closer inspection of the ecu it is burnt out in places so i havent tried programming again im going to find a faulty ecu on ebay and reprogram it with this file youve posted

[dragon100]

Ok ..............

[bubbles69]

hi there i have new module trying second file now will let you know

[bubbles69]

im stressed light still on lol pls can someone confirm these dumps are def ok?

[bubbles69]

scanner shows 25 dtcs with last posted cleared file when i try to erase codes i get clear codes fail message

[kolocar]

check it and report

[bubbles69]

Hi thanks witch is difference c1 c2.bin do i need to try both?

[juozas10]

Hi
Try.
B.R:wink:

[bubbles69]

right ok i programmed last file posted i now have 20 dtc witch are unknown codes but clear codes says completeed but still there i think there is still a error in dump does anyone have a teste ddump i can try

[bubbles69]

anyone help...!!

[bubbles69]

check it and report


tried c2.bin still 20 dtc detected all unknown codes so must be problem with dump you are clearing first file i posted yes

[bubbles69]

Pls someone help with this dump

[keturi]

The first thing what you have to do, connect to the diagnostics this cars NOT as Ford, but as Fiat 500, then you will have more possibilities. I will have a look a look about crash data now. My file should be ok, but don't forget, in about 20% cases control unit should be replaced for these cars if shows control unit error fault code.

[bubbles69]

Thanks for your reply I've not tried connecting to airbag ecu via fiat but it does see ecu ok under ford and thanks for taking your time to re check the dump

[keturi]

Have a look edited post above

[bubbles69]

Ok thanks I will try this today or Monday and let you know

[bubbles69]

Ok programmed this file I have read ecu under fiat I know have 3 codes

One I'm worried about is B0100 error inside control unit

Other says driver pre tensioner present does this mean dump is still wrong or?

Regards

[bubbles69]

Here is screen shot

[bubbles69]

Still need help ecu file still bad thanks

[bubbles69]

Someone must have solution to clear this dump I've never had this much problem

[credoline]

With the last file, if clearing is good, you will be able to produce new DTC when disconnect some component of airbag system.