How read mazda 2500 2004?

[Dr. Zoidberg]

How read this car whit carprog clone?

[Triniguy]

use Tacho pro. Just 4 wires to solder on, very easy.

[Dr. Zoidberg]

use Tacho pro. Just 4 wires to solder on, very easy.

Thank mate, but i have only carprog and digiprog, thank!

[Triniguy]

Try digiprog Ford Ranger file. Same panel as Mazda2500/2600.
Ford Ranger and Mazda 2500 is same car.

Regards

[Triniguy]

I always have to write KM and tool program miles. For example if I want the odo to show 62137 i have to program 100000. That is with tacho pro. Never program this vehicle with digiprog.
That is actually the only vehicle that I use the Tacho Pro for, lol

[juancho18]

Remove clusters, Read eeprom, file ok

[jomberykaso]

Thank mate, but i have only carprog and digiprog, thank!



You must to solder 4 wires like these pictures. (this is called cable 51 or stecker 51)

393437 393438 393439

Then, Use your Digiprog and select Ford - Ranger - Diag.

Digiprog will show you an incorrect mileage, don?t worry, just put your desired mileage and all will be fine.

(After programmation, if mileage is incorrect for you (on Display), just write your disired mileage in Miles, not in Kilometers)

Example: If you want to write 156.234 kms in this cluster, Multiply 156.234 by 1.6 then write the result. 156.234 * 1.6 = 249.974, put 249.974 on Digiprog, the Display of cluster will show you 156.234 kms

Good Luck!

[jomberykaso]

Or you can use this information: (for Upa programmer)
393447393448393449393450393451

[jomberykaso]

.........................
393452393453

[ascotauto]

Hi
I tried this method it does not work. Can 05x visteon be read in circuit with orange?

[dimahar]

jomberykaso
Digiprog and select Ford - Ranger - Diag its COOL :rock:
Coeficient must be *1.61 for writed milage